
High Power Ultrasonic Cleaner Kit
CAT.NO: KC5499
High Power Ultrasonic Cleaner Kit
CAT.NO: KC5499
Ref Silicon Chip Magazine September 2010Most people would know that you can get small ultrasonic cleaners for jewellery and similar small items, so wh...
$124.50
Bulk Pricing:
1-4 | $124.50 |
5+ | $112.00 |
Out Of Stock
Description
Ref Silicon Chip Magazine September 2010
Most people would know that you can get small ultrasonic cleaners for jewellery and similar small items, so why not a much larger version? It would be ideal for cleaning automotive and other mechanical parts, fabrics which can't be machine washed, ornate bric-a-brac and a host of other hard-to-clean items. You can use a variety of receptacles for a tank, such as an old cistern or laundry tub. It can also be used with solvents such as kerosene or just water and detergent. The kit includes the transducer, case, cable and electronics and can be powered from a 2.5A 12VDC plugpack. Everything is included in the kit except for a housing for the transducer and sealant. For sealant you can use any neutral cure silicone suitable for wet areas. You'll also need epoxy resin such as Araldite or JB Weld, and for a housing, a short piece of 65mm PVC plumbing pipe and a drain, waste and vent end cap available from any plumbing supplier will do the job.
Specifications:
• Power requirements:12V, 2.5A
• Transducer voltage: 250VAC square wave
• Frequency range: Main mode 19kHz to 42kHz
• Timeout adjustment: 30s to 10m
Most people would know that you can get small ultrasonic cleaners for jewellery and similar small items, so why not a much larger version? It would be ideal for cleaning automotive and other mechanical parts, fabrics which can't be machine washed, ornate bric-a-brac and a host of other hard-to-clean items. You can use a variety of receptacles for a tank, such as an old cistern or laundry tub. It can also be used with solvents such as kerosene or just water and detergent. The kit includes the transducer, case, cable and electronics and can be powered from a 2.5A 12VDC plugpack. Everything is included in the kit except for a housing for the transducer and sealant. For sealant you can use any neutral cure silicone suitable for wet areas. You'll also need epoxy resin such as Araldite or JB Weld, and for a housing, a short piece of 65mm PVC plumbing pipe and a drain, waste and vent end cap available from any plumbing supplier will do the job.
Specifications:
• Power requirements:12V, 2.5A
• Transducer voltage: 250VAC square wave
• Frequency range: Main mode 19kHz to 42kHz
• Timeout adjustment: 30s to 10m
Specifications
Warranty: 3 Months
DELIVERY
CHECK IN-STORE
Have a question ?
Call our Techstore
on 1800 022 888
Call our Techstore
on 1800 022 888